Water pooling in your yard: what to investigate before renting equipment

Match the symptom to its likely cause first. The machine comes after.

What are you seeing?

Pick the symptom that matches your yard. Each one lists the causes to rule out before any machine is booked.

Likely causes to check

Rent equipment only after

A low spot that holds water for days

Water has nowhere to go

A puddle that lasts days after rain usually sits in a spot lower than everything around it, with no path out. Sometimes the soil under it is tight clay that will not drain down. Either way the fix is to give the water a route to a lower point, or to raise the low spot so water sheds off.

Walk the yard during or right after a rain and watch where water runs and where it stops. Find the nearest point lower than the puddle: a ditch, a swale, a storm inlet, or the edge of the property where runoff already goes. If there is one, a French drain or a shallow swale from the low spot to that outlet is the usual repair. The Ditch Witch trencher cuts a 6 in wide slot to 36 in deep for a straight drain line. If the route has roots, rock or needs a wider trench, the Bobcat E10 or E35 digs it. If there is no lower point to drain to, the repair is regrading and filling, which is a loader and topsoil job, and it often still needs a professional's opinion on where the water will end up.

  • A downspout or sump discharge empties uphill of the puddle. Fix the source before digging.
  • The spot was recently backfilled (new septic, utility work, a removed pool or tree) and is still settling.
  • Clay soil: a perk test with a post hole and a bucket of water shows whether the ground drains at all.
  • No lower outlet exists: a drain line cannot push water uphill, so the plan changes to fill and grade.
  • You have found an outlet point lower than the wet spot and confirmed you are allowed to send water there.
  • You have measured the run length and the drop from the wet spot to the outlet.
  • MISS DIG 811 has been contacted at least three business days before you dig.
  • trencher
  • e10
  • e35

Water against the house or in a window well

Downspouts and grading near the wall

Most water at a foundation comes off the roof. A downspout that dumps at the wall puts a large volume of water into a small area every storm. Soil that slopes toward the house instead of away from it holds that water against the foundation.

Check each downspout during a rain. Water should leave the splash block and keep moving away from the house. If it pools at the wall, the first repair is extending the downspout underground to a point away from the building, which is a shallow narrow trench. The trencher fits that job in open lawn. The E10 fits when the route is tight against the house or full of roots. Grading that slopes toward the house is a separate fix with fill and a rake. A window well that fills needs the water pumped out now (the garden-hose submersible utility pump handles a window well) and then the same downspout and grading check.

  • A downspout extension that was buried years ago may be crushed, full of roots or frozen. Flush it and watch for the outlet to flow.
  • Water in the basement, cracks in the foundation, or a wet wall that is not near a downspout: that is a professional's call, not a rental job.
  • Window well with no drain in the bottom: pumping it is a stopgap. Where the water comes from is still the question.
  • Sump pump discharge that empties right next to the house recycles the same water.
  • You have watched the downspouts during a rain and know which ones are the problem.
  • You know where the extension will discharge and that it is allowed there.
  • Any water inside the building has been looked at by someone qualified to judge the foundation.
  • trencher
  • e10
  • submersible-utility-pump-3-4-discharge

The whole lawn stays soft and spongy

Tight soil or a high water table

When a yard is soft everywhere rather than in one place, the problem is usually the soil itself or the water table under it. Heavy clay holds water at the surface. A high water table keeps the ground saturated from below. Neither is fixed by one trench.

Dig a test hole with a shovel or a post hole auger about 2 ft deep and fill it with water. If it is still full the next day, the soil does not drain. Also check whether the yard sits lower than the neighbors' lots or a road, which means you are receiving their runoff. A lawn like this sometimes improves with core aeration and topdressing over a few seasons. A drainage system across a whole yard is a designed job with a surveyed outlet, and that is where a drainage contractor earns the fee. Ward's can supply the trencher or excavator to a contractor's plan or to yours, but the plan has to come first.

  • The lawn is wet only in spring and dries by June: seasonal water table, often lived with rather than fixed.
  • Wet in one band across the yard: could be a buried spring line, a broken irrigation pipe or a septic drain field that is failing. A failing drain field is a health department matter.
  • A neighbor's new grading or downspouts recently changed where water goes.
  • Tracks on a loader or excavator spread weight, but they do not make saturated ground workable. After a hard rain, give it a day before any machine rolls on it.
  • You have done a drainage test hole and know whether the soil drains at all.
  • You have ruled out a septic field, irrigation leak or sump discharge as the source.
  • A drainage plan with an outlet exists, from you or a contractor.
  • little-beaver
  • trencher
  • e35

Water runs across the driveway or washes out the edge

Runoff is taking the wrong path

Water crossing a driveway or cutting its edge is moving water, not standing water. It has a route; the route is just across your drive. A clogged culvert, a silted ditch or a drive that sits lower than the road are the usual reasons.

Look at the culvert under the driveway apron. If it is half full of silt or crushed, water backs up and goes over the top. Look at the roadside ditch and any ditch along the drive; if they have filled in, water leaves them. Cleaning a ditch and re-establishing its fall is excavator work: the E35 with a bucket, or the E10 if space is tight. Culvert replacement means setting pipe, and the E48 adds reach and lift for that. Once the water has its path back, the drive itself usually needs re-grading and compaction, which is a loader and roller job covered in our driveway material.

  • Potholes that keep returning are a drainage and base problem first. Regrading alone does not hold.
  • A culvert under a public road, or any work in the road right-of-way, needs the road commission or township involved before you touch it.
  • Washouts after every storm on a steep drive may need a designed water bar or swale, not just a cleaned ditch.
  • You know whether the culvert and ditch are on your property or in the right-of-way.
  • You have watched where the water comes from upstream of the drive.
  • MISS DIG 811 has marked the area, since utilities often run along the road edge.
  • e35
  • e48
  • roller

Water is standing right now and needs to go

Move the water, then find the cause

Sometimes you cannot wait for an investigation. A flooded window well, a crawl space with water in it, or a pond over a work area needs a pump today. Pumping buys time; it does not fix anything.

Ward's pumps are clean-water pumps. Indoors, in a basement, crawl space or sump pit, the 2 in electric submersible is the pick because it has no exhaust. A window well, hot tub or shallow puddle with a garden hose to the outlet is a job for the 3/4 in submersible utility pump. Outdoors, for a pond, a flooded excavation or job-site water, the 3 in gas centrifugal pump moves the most water but runs outdoors only. Every electric pump runs through a GFCI outlet. Tell us how far the water has to travel and how high it has to lift so we can send enough discharge hose.

  • Floodwater from a river, drain backup or sewage: that is not a rental pump job. Call a restoration or plumbing professional.
  • Mud, leaves and debris in the water will clog a clean-water pump. Clear the intake area first, or ask us before you rent.
  • Water that comes back as fast as you pump it: the source is active (a spring, a broken line, a high water table) and pumping alone is not a plan.
  • Where the discharge goes matters. Sending it to a neighbor's lot, the street or a storm drain may be restricted locally.
  • You know the water is clean, not sewage or floodwater.
  • You have a legal place to send the discharge and a route for the hose.
  • You have a GFCI outlet in reach for an electric pump, or the space is outdoors for the gas pump.
  • submersible-pump-2-discharge
  • submersible-utility-pump-3-4-discharge
  • centrifugal-pump-3-discharge

Why the investigation comes before the rental

  • A trench dug in the wrong place is a wet trench. Most yard drainage repairs fail for one of three reasons: the water source was never found, the outlet is not lower than the problem, or the ground does not drain and the trench just fills. An hour in the rain with a notebook answers most of this for free.
  • Write down where water enters the yard, where it collects, and where it leaves if it leaves at all. Measure the drop from the wet spot to the lowest point you can legally discharge to. Note the soil. Then the equipment question is simple: a narrow straight run in open lawn without obstacles is trencher work, anything wider, deeper or rooty is excavator work, and water that has to move today is a pump.

When to bring in a professional

  • Some water problems are outside a rental fix. Water inside a basement or behind a foundation wall, a yard that stays wet all season regardless of weather, a septic drain field that is surfacing, or any floodwater from a river or sewer backup. Those need a drainage contractor, a plumber, a foundation specialist or the health department, in that order of likelihood.
  • Ward's rents the trencher, the excavators and the pumps to homeowners and to contractors. If a contractor is doing the design, we are happy to supply the machine to their plan. If you are not sure which side of the line your yard is on, call or text and describe what you see.

Before you book, check the site.

Measure the narrowest opening

The trencher is 35.8 in wide and the E10 retracts to 28 in. The E35 is 69.7 in. Measure the clear opening with the gate fully open and include latches, posts and the turn into it.

Walk the route when it is wet

Drainage jobs happen on wet ground. Tracks spread weight but do not stop rutting on a saturated lawn. After a hard rain, give it a day. Note septic fields, irrigation heads and buried lines on the path.

Bring the numbers

Run length, depth at the deepest point, the drop from start to outlet, and for pumps the distance and lift to the discharge point. These decide the machine and the hose.

Before ground disturbance: — contact MISS DIG 811 at least three business days before digging or trenching. It is free and required by Michigan law. MISS DIG does not mark private lines such as irrigation, invisible fence or a line to an outbuilding.

Your drainage investigation checklist

Save these details before you request equipment.

  • Where water enters the yard, where it collects, where it leaves
  • Downspouts and sump discharge locations checked during a rain
  • Drainage test hole result (does the soil drain overnight?)
  • Outlet point lower than the wet spot, and permission to discharge there
  • Run length, depth and drop measured
  • Narrowest access point and turning space
  • MISS DIG 811 ticket date

Let's match the machine to your job.

Tell us what you're working on. Our Hamburg team serves Southeast Michigan, seven days a week.

(810) 231-7368

Explore equipment for this guide

Questions before you rent

Can I just rent a trencher and dig a drain where the water sits?

You can, and it works when there is a lower point for the water to reach. The trencher cuts 6 in wide and up to 36 in deep, which suits a straight drain line in open lawn. What it cannot do is make water run uphill. If the wet spot is the lowest place on the property, a trench there just becomes a long puddle. Find the outlet first, measure the drop, and then book the machine.

How do I know if it is my soil or my grading?

Do both tests. For grading, watch the yard in a rain and see whether water arrives from somewhere higher and stops in one spot. For soil, dig a hole about 2 ft deep, fill it with water, and check it the next day. A hole that is still full means the soil does not drain, and a trench without an outlet will hold water the same way. Clay soil plus a low spot is the common combination, and it needs an outlet more than anything else.

Do I need MISS DIG for a shallow drain line?

Yes. Michigan law requires contacting MISS DIG 811 at least three business days before digging or trenching, and it is free. Gas, electric, cable and phone lines are often shallow near the house and along the road. MISS DIG does not mark private lines, which includes irrigation, landscape lighting, invisible fence and a line from the house to a shed or barn. A rental metal detector can help you look for those but does not replace the locate.

Which pump do I need to get rid of the water now?

Ward's pumps handle clean water. Indoors, in a basement, crawl space or sump pit, use the 2 in electric submersible; it is safe indoors because it has no exhaust. A window well, hot tub or puddle with a garden hose run is the 3/4 in submersible utility pump. Outdoors, for a pond or flooded excavation, the 3 in gas centrifugal pump moves the most water and runs outdoors only. Electric pumps plug into a GFCI outlet. Tell us the distance and the rise to the discharge point so we send enough hose.

How does the equipment get to my house?

The trencher rides on our 5x10 utility trailer with a 2 in ball, which most pickups handle. The E10 and E35 ride on the 16 ft equipment trailer with a 2 5/16 in ball, and the E35 needs a 3/4-ton truck or larger. Pumps fit in a car or truck bed. Delivery runs seven days a week on our trucks and is priced by drive time from Hamburg: $85 round trip within 45 minutes for a trencher or excavator load, $125 at 46 to 75 minutes, and a quote beyond that. The fee is confirmed at checkout.

When should I stop and call a drainage contractor?

When the water is inside the house, when the whole yard stays wet all season, when a septic field is involved, or when there is no outlet lower than the problem. Those jobs need a design and sometimes permits. A contractor can still rent the trencher or excavator from us for the dig; many do. If you are unsure, send us photos and the measurements from the checklist and we will tell you what we think.